Subject	How much is a fair price for Powder Coating???>>
Posted by	SniPer SR71 (Dallas) on December 10, 2002 at 9:43 PM
	This message has been viewed 116 times.
Message	I initially took a total of 19 engine parts to Quality Powder Coating Inc. in Carrollton, TX. I have heard from some of the others on the board that they had good results with Quality PC Inc. How does price compares to others that have similar work done by them or a different company? 276.00 with Tax The parts I had PowderCoated are as follows (total of 17 parts): 1. 1 Plenum 2. 2 front water pipes 3. 4 hard pipes 4. 6 coil pack brackets 5. 4 valve covers (Initially two turbo inlet tubes). Anyone care to hear the complete story and BS excuses along with three months of turnaround, e-mail me and I’ll be happy to tell you WazZZ up. Gary
Follow Ups	How much is a fair price for Powder Coating???>> - SniPer SR71 (Dallas) 21:43:40 12/10/02 $200 sounds a little more like it, IMOP. (n/m) - Milo (San Antonio, TX.) 21:49:07 12/10/02 three words. DIY. (n/m) - AshsZ (King of FAB) 21:50:09 12/10/02 thats actually 3 letters :-) (n/m) - TARGETZ 21:51:44 12/10/02 I'd rather focus energy on more useful tasks. - SniPer SR71 (Dallas) 22:07:01 12/10/02 Fat people say its what's on the inside that matters> - AshsZ (King of FAB) 10:00:43 12/11/02 not sure I understand how it applies? (n/m) - SniPer SR71 (Dallas) 19:45:16 12/11/02 Hmm, that really doesn't sound too bad to me. - Woody75 (Denver) 21:52:28 12/10/02 I was hoping for 220.00 +tax Max. (n/m) - SniPer SR71 (Dallas) 21:58:23 12/10/02 Well next obvious question would be... - Woody75 (Denver) 08:28:38 12/11/02 Of course I did, Before dropping all the parts off>>> - SniPer SR71 (Dallas) 19:44:20 12/11/02 Blasting is about $20 and hour so it seems right. - Woody75 (Denver) 21:04:21 12/11/02
Post a Followup	You cannot reply to this message because you are not logged in.