|
process of doing it on another rear end. Basically, you will need the following items: Hydraulic Press (I bought a 20 Ton from Harbor Freight, you could probably get a lesser one but I got it on sale it was only about 15 bucks more than the 12 ton) Compressor & Impact Gun, this helped alot with getting some of the stubborn bolts off. Then it was more or less just figuring out how to line up the press to push out the busshings on the spindles and all of the control arms. Unfortunately we didn't document any of the process we used for the different bushings, which we probably should have. Cause now we have to do it again, and will probably spend time spinning our whells trying to remember how we did some of them. Putting the bushings in was easy. Once the old ones are out the new ones slide right in. Anyways, when we finish the process this time we are going to document all of it. Aaron
-------------------------------------------
Custom HOWE Radiator 365 SHIPPED
http://www.lvcm.com/gotboost/howe.htm |
