Subject	if Santa brought me a torque wrench, do I want a 3/8 or 1/2"
Posted by	my91z on December 05, 2002 at 1:16 PM
	This message has been viewed 49 times.
Message	drive? What do you guys use? I figure I want something that will show 150 ft-lbs somewhere in the 50%-75% of it's scale so that it's not right at the end where accuracy drops off. A 3/8" would be smaller and have better clearance, but a 1/2" would go to higher torques and be more durable.... Comments? Thanks, Mike ------------------------------------------------------
Follow Ups	if Santa brought me a torque wrench, do I want a 3/8 or 1/2" - my91z 13:16:44 12/05/02 both, but I do tend to get a bit more use out of the 1/2" (n/m) - ibrandt 13:21:59 12/05/02 1/2" with a 3/8" adapter :) (n/m) - sbsTT(MD) 13:22:46 12/05/02 2nded (n/m) - boileralum00 13:26:58 12/05/02 Don't adapters screw with the readings? (n/m) - JRH(KY) 13:40:02 12/05/02 Not any more so than using a deepwell or different size - boileralum00 13:47:25 12/05/02 Get a Snap On TQFR250 model >> - Mal1ce 14:09:24 12/05/02 heh, I don't think Santa is going to be THAT generous :-) (n/m) - my91z 14:32:46 12/05/02
Post a Followup	You cannot reply to this message because you are not logged in.