Subject	Just how strong is JB Weld check this out
Posted by	MikeH(Phoenix) on November 08, 2000 at 8:14 PM
	This message has been viewed 35 times.
In Reply To	Re: Egr and stuff posted by Chuck S. on November 08, 2000 at 05:40 PM
Message	Tensile Strength 3960 PSI Adhension 1800 PSI Flex Strength 7320 PSI Tensile Lap Shear 1040 PSI Resistent to 500 degrees F. Withstands Water, gasoline, chemicals, acid. Been used to repair blocks, and cylinder heads. Should be more than adequate to block off EGR Hole
Follow Ups	My thoughts of working on the Z's engine (long and ramlbing) - John Y(Houston) 15:46:25 11/08/00 Interesting reading... (n/m) - GTR 16:40:20 11/08/00 I agree the Zs engine looks intimidating to work on but - powerZlide 16:53:36 11/08/00 The tranny bolts.... - teahead 16:57:45 11/08/00 I tried it that way... - John Y(Houston) 21:58:12 11/08/00 Egr and stuff - MikeH(Phoenix) 17:15:48 11/08/00 Hows your beast coming along? - snoguitar 17:24:48 11/08/00 Re: Egr and stuff - Chuck S. 17:40:00 11/08/00 JB weld is very strong epoxy with metal. Go to their website (n/m) - MikeH(Phoenix) 17:45:30 11/08/00 There is silicon hose specific for coolant (n/m) - MikeH(Phoenix) 17:55:54 11/08/00 Just how strong is JB Weld check this out - MikeH(Phoenix) 20:14:10 11/08/00 I'll call ya tomorrow. (n/m) - John Y(Houston) 22:04:29 11/08/00 Heheheh, that's a good idea. Thanks! (n/m) - John Y(Houston) 22:02:49 11/08/00 The trick is putting everything back together !!! (n/m) - PLEAZURE in CA 17:21:57 11/08/00 Or you take the test drive and downpipes leak (n/m) - NONE 17:25:38 11/08/00 make sure you bypass all the water lines under the manifold (n/m) - MikeH(Phoenix) 17:24:00 11/08/00 I thought the lines keeps the sludge/oil from accumulating - PLEAZURE in CA 18:08:01 11/08/00 That's pcv... not coolent. (n/m) - NVMYZTT [ BUSH-CHENEY 2000 ] 18:50:12 11/08/00 Yep! I have your injector tech page printed up. (n/m) - John Y(Houston) 22:03:10 11/08/00
Post a Followup	You cannot reply to this message because you are not logged in.