TwinTurbo.NET: Nissan 300ZX forum - Mike, any plans to manufacture some of the custom parts >
People Seeking Info
 
   


     
Subject Mike, any plans to manufacture some of the custom parts >
     
Posted by Z-Jay (Stored for WINTER!) on November 21, 2002 at 6:43 PM
  This message has been viewed 57 times.
     
In Reply To Reply to posts about SCC's Project Z posted by morepower2 on November 21, 2002 at 12:39 PM
     
Message you developed during your project? Perhaps collaborating with someone like Greg Dupree for fabrication?

For example, your custom turbo inlet pipes (on the compressor inlet side) that are less restrictive than stock. There would probably be some good interest in those. Also, your wheelwell fender-liner ducts for the intercoolers. etc...

Keep up the good work. I look forward to hearing more about your developments.


Z-Jay
Edmonton Z Car Club
93 300ZX TT - Stage VI
01 Sentra SE - daily driver
HEY HANDS OFF THE Z

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.