Subject	not beating a dead horse but>>>
Posted by	SL103 on November 12, 2002 at 10:38 AM
	This message has been viewed 129 times.
In Reply To	In the same situation---> posted by Miles (San Antonio, TX) on November 12, 2002 at 10:10 AM
Message	im sure you heard the controvrsy w/ me and gamblerZ i would suggest the extrude hone manifolds because according to Charlie the ported ones were nominal(flow). Or get them done from Miles i will no longer do manifolds for that reason. Shawn Lane Z less NOW :( but my Quest is on for a new 300ZXTT!
Follow Ups	Extrude hone exhaust manifolds, really worth the $500? - Turbodog (CT) 09:54:00 11/12/02 In the same situation---> - Miles (San Antonio, TX) 10:10:04 11/12/02 not beating a dead horse but>>> - SL103 10:38:11 11/12/02 That is why I don't sell that service. (n/m) - Miles (San Antonio, TX) 11:15:44 11/12/02 Um, according to extrudehone.com it's almost $1200.oo - niXit 10:53:03 11/12/02 Well...... that sucks. (n/m) - Miles (San Antonio, TX) 11:16:18 11/12/02 Where do you see that? - Turbodog (CT) 11:18:06 11/12/02 I called last week, they told me 500$ (n/m) - Hungryjack 11:28:33 11/12/02 I thought it was $500 for each manifold? - Marshall 13:20:38 11/12/02 They said for both. They said it didn't matter what - Hungryjack 14:43:49 11/12/02 I called 6 months ago and was told 550(?) for each (n/m) - niXit 10:10:19 11/13/02 I should have flow data on EH manifolds in a week or so >> - Mal1ce 11:34:26 11/12/02 Thanx, Mallice. (n/m) - Miles (San Antonio, TX) 12:25:07 11/12/02 can that be a sticky for a couple days so nobody misses it? (n/m) - Chris(NJ) 17:33:43 11/12/02 They R in da same league with Stealin and Microsoft=Monopoly (n/m) - Arturo C. 11:45:55 11/12/02 I call them extrudeWhore, they are a monopoly (n/m) - MikeH(Twin GT35BB Incon Z) 12:46:09 11/12/02 I had mine done and really didn't see much difference - MikeH(Twin GT35BB Incon Z) 12:45:23 11/12/02 It should be more than just polished, shouldn't it? - Marshall 13:19:30 11/12/02 yes, it should make the inside diameter bigger (n/m) - Jefe 13:22:33 11/12/02 Exactly what I needed to hear, just to clarify --> - Turbodog (CT) 13:31:36 11/12/02 Re: Exactly what I needed to hear, just to clarify --> - MikeH(Twin GT35BB Incon Z) 14:09:27 11/12/02 Thank you much sir! - Turbodog (CT) 14:31:38 11/12/02 Greg had his done. I made boost 500rpm earlier with porting. - xybertron 00:47:34 11/13/02
Post a Followup	You cannot reply to this message because you are not logged in.