Subject	Hate to tell you this bro, but you have made a BIG mistake
Posted by	AshsZ (The Rebuild King) on November 04, 2002 at 2:56 PM
	This message has been viewed 94 times.
In Reply To	*Help needed*Question for engine rebuilders..... posted by Supaman on November 04, 2002 at 09:01 AM
Message	You will need to replace the bolts, perhaps even the rods themselves. You have a service manual with a typo. I had the same one. The proper tightening torque is only 28-32 ft/lbs of torque. You have stretched your rod bolts and they must be replaced. I sheared a couple of mine off until I found that there was a typo. Call 1800-nissan1 and bitch at them for the misprint. Have THEM pay for the replacements. [ ashleypowers.com ] [ agpowers@bellsouth.net ] When pigs dance, you better get it on video... "You never really learn to swear until you learn to drive." -George Carlin
Follow Ups	*Help needed*Question for engine rebuilders..... - Supaman 09:01:41 11/04/02 I didn't have that problem but,... - Hawk 09:18:35 11/04/02 Were you able to spin the crank easily before >> - SlicktopTT 09:53:54 11/04/02 Are you sure it's not just the pistons providing friction? (n/m) - Woody75 (Denver) 10:21:21 11/04/02 As below if rods and pistons in it will not spin - RT 11:10:18 11/04/02 Hate to tell you this bro, but you have made a BIG mistake - AshsZ (The Rebuild King) 14:56:23 11/04/02 Man, thats absolute bullshit. (n/m) - Bobby12many(SIgWhore) 20:03:06 11/04/02 My words exactly. One of the MOST critical parts in the - AshsZ (The Rebuild King) 07:30:14 11/05/02 Leave the short block engine building to professionals (n/m) - MikeH(Twin GT35BB Incon Z) 17:51:58 11/04/02
Post a Followup	You cannot reply to this message because you are not logged in.