Subject	Kind-of-Repost: Identifying wires on Ign Solenoid Cylinder
Posted by	Bobby12many(SIgWhore) on October 29, 2002 at 3:55 PM
	This message has been viewed 153 times.
Message	Well, I just got done installing my push button starter and I ran into a slight problem with the buttons ability to start the car. If you are interested my post about the problem, it can be found in TECHNICAL. Now to my question. As a source for my 12v ACC requirement for the button I used the AUDIO/ACC outlet in the interior fusebox. After talking to a couple people regarding my problem, they all have suggested to use the same power source the stock ignition solenoid feeds off of instead of an accessory source. Seeing as though I dont currently have access to a Multimeter I havent the foggiest Idea of which wire is the 12v ACC source. I Know it is not the Black/Yellow wire on the far left. If anyone has a service manual and could look it up for me, or scan it for me, I would me extremely grateful. Here is a pic of the terminations of the Ignition SOlenoid Cylinder. I almost have my writeup done at this point with pictures, but I need to get this issue figured out before I give anyone explcict directions. Reforms come from below. No man with four aces howls for a new deal. - Fundamental Tenet of Reform My sounddomain page Leave some feedback on my site!
Follow Ups	Kind-of-Repost: Identifying wires on Ign Solenoid Cylinder - Bobby12many(SIgWhore) 15:55:58 10/29/02 c'mon, someone with a service manual help a man out! :) (n/m) - Bobby12many(SIgWhore) 16:40:22 10/29/02 Check email. (n/m) - Arturo C. 16:53:14 10/29/02 Two words for ya, Radioshack- multimeter, or use your tongue (n/m) - MikeH(Twin GT35BB Incon Z) 17:38:28 10/29/02 lol (n/m) - PePSiRuLEz13 00:59:46 10/30/02 Installing electrical device without mulitmeter..hmmm? (n/m) - MikeH(Twin GT35BB Incon Z) 17:18:43 10/29/02
Post a Followup	You cannot reply to this message because you are not logged in.