Subject	I wasn't pay attention
Posted by	Jess300zTT on October 14, 2002 at 9:42 AM
	This message has been viewed 50 times.
In Reply To	Tsk tsk. Sure you know what you're lookin @? Not a HEMI. posted by teahead on October 14, 2002 at 09:35 AM
Message	I heard him say it was a hemi 'cuda. Probably referring to when it was stock. For all I know, the other engine he uses is probably the original.
Follow Ups	NZR: TT Hemi 'Cuda w/ NOS! - Dialup semi-welcome - Jess300zTT 08:09:43 10/14/02 I wonder if he asked about the NA->TT conversion. :) (n/m) - AshsZ (The Rebuild King) 08:16:31 10/14/02 Interesting. He's using an HKS EVC IV. (n/m) - John(Houston) 08:21:56 10/14/02 That's all american for ya. (n/m) - Miles (San Antonio, TX) 08:54:55 10/14/02 Joe Dirt "It's got a Heemmie" (n/m) - dragonballz 08:24:01 10/14/02 If it was mine - I'd drive that bitch! I'll never understand (n/m) - Keith58 08:24:05 10/14/02 "He only uses that motor for the dyno and car shows" :sigh: (n/m) - Guapo 08:29:40 10/14/02 Yep, what a waste.... (n/m) - RSR 10:28:00 10/14/02 I prefer your car--very nice looking! (n/m) - stupidfast 09:07:56 10/14/02 Thanks. So was yours (n/m) - Jess300zTT 09:24:46 10/14/02 thanks--thought nobody would remember mine =) (n/m) - stupidfast 17:21:19 10/14/02 Tsk tsk. Sure you know what you're lookin @? Not a HEMI. - teahead 09:35:03 10/14/02 I wasn't pay attention - Jess300zTT 09:42:35 10/14/02 He's blowin smoke, later cudas didn't have HEMIs - teahead 09:54:18 10/14/02 ...and only an idiot would modify an original hemi like that (n/m) - Grec (East Bay, CA) 10:09:32 10/14/02 Had a FMIC, but small compared to most I've seen on Z's (n/m) - Jess300zTT 10:19:43 10/14/02 At 14psi that big block V8 should put out more than - MikeH(Twin GT35BB Incon Z) 11:09:29 10/14/02 Looks 100% identical to a Buick Grand National V6. - nixit(da][as) 13:40:14 10/14/02 (oh yea, DEFINENTLY not a hemi. No way) but very respectable (n/m) - nixit(da][as) 13:46:35 10/14/02 Hemi or not, I'm pretty sure it's a beast. (n/m) - TheKevin 16:09:17 10/14/02
Post a Followup	You cannot reply to this message because you are not logged in.