Subject	check the clutch slave & master cylinder for leaks
Posted by	Zustenon on November 04, 2000 at 11:42 AM
	This message has been viewed 24 times.
In Reply To	NZR. The RX7 won't go into gear, can anyone help? >>> posted by BreeZ on November 04, 2000 at 10:19 AM
Message	or air in the system. Also make sure fluid level is adequate in teh reservoir. Bleed system if not leaks & adjust clutch : We were out last night messing around and my husband tached it up to about 7000 and dropped the clutch. He said it was kind of hard to get it into 2nd after we peeld out but then it wouldn't go into 3rd at all. So we were stuck in the turn lane of a 4 lane road. We turned th car off and it will go into all gears, but when it's on it won't go into any gear at all. We had to restart it in 1st and limp back to his office in 1st gear. We just left the car there. : Do anyone have any idea what happened? : He has an ACT 6 puck clutch and a lightweight flywheel in it that have ~9k miles on them.
Follow Ups	NZR. The RX7 won't go into gear, can anyone help? >>> - BreeZ 10:19:27 11/04/00 Busted Syncros? (n/m) - Carlos Ramirez 10:56:13 11/04/00 try adjusting it.. - orion 11:17:24 11/04/00 That makes sense. he's going to try to adjust it... - BreeZ 11:59:57 11/04/00 E-mail NIZZAN, he should help :) (n/m) - ZBlacktt 11:26:00 11/04/00 Actually, yeah he can help it happened to him - KILLR300ZX 12:10:30 11/04/00 check the clutch slave & master cylinder for leaks - Zustenon 11:42:32 11/04/00
Post a Followup	You cannot reply to this message because you are not logged in.