|
: Went into the shop where I do my dyno runs and set up another Dyno Day for our Z club in NOV. Now I've seen this Vette in here before, but it had a Supercharger set up on it. Then I seen it come back and shop owner busted out some of the new parts at that time and I was like Guy has no budget, that's for sure. This is just one guys project car and that's all. No Sponsers or racing daily or anthing. : Can you spot off the custom in this picture, from full 3" exhaust, manifolds, MSD, full 3" IC piping, so on and so on. They built this whole car from the ground up. The whole suspension is custom built ( whole ). That intake piping that is rubber in this PIC, is there to keep dust out. They have a polished one for it. They broke in the motor and dyno ran it and motor only at the time got 450rwhp they said. Now that added turbo's that are somewhere in the line of TD05/18'g's on top of that 450rwhp motor power ( sickening ).
: 
: 
: 
: 
: This is a brand new Z06 6Spd tranny built with a twin plate clutch set up. This is upp in the car when I took this today, hard to tell...
:  : Custum 3" FMIC, very nice work.
:  : Full big brake system on ALL 4 wheels. Rims little dirty, but hey, it's in the shop,lol. Car has 315's on the back.
:  : HKS BOV's and all custom piping, just mad money everywhere on this car. :  : MSD and a few other computer control set ups I seen on this car :  : Check this shit out! The car is looking to put down 700rwhp with TQ to match. So they built a full custom rear end with 3" steel drive line's. Now that's looks tough as sh*t. :  : This car looks full on sleeper too. Other than nice brakes and exhaust out the back, that's all you see. He will break many takers spirit, that's for sure.
"If Speed Kills, You're Talkin' to a Dead Man." "If the front end hits the wall, it's understeer. If the rear end hits the wall, it's oversteer". - Bobby Unser Every group has morons, it's finding the right mix. --SeedyRom on June 26, 2002 at 11:48 am |
