Subject	I've done the same thing. We machined a block of aluminum
Posted by	TTony on September 27, 2002 at 9:47 AM
	This message has been viewed 45 times.
In Reply To	Lol, is that standard proceedure then :) (n/m) posted by Woody75 (Denver) on September 27, 2002 at 07:54 AM
Message	to hold the spring down while replacing the belt. When the belt is on, just take the block out and it springs back into tension. Works great and has saved me $250 in tensioners so far. :-) Manual "Z" pedal group buy ends October 7. Click here for the info.
Follow Ups	Caution on an Ebay ad for belt tensioner.... - Woody75 (Denver) 07:36:35 09/27/02 You can push it back in and reuse it. - John(Houston) 07:52:08 09/27/02 Lol, is that standard proceedure then :) (n/m) - Woody75 (Denver) 07:54:52 09/27/02 I've done the same thing. We machined a block of aluminum - TTony 09:47:39 09/27/02 So your pushing the pin back in and then adding the block? (n/m) - Woody75 (Denver) 10:53:10 09/27/02 Yep. (n/m) - TTony 14:05:02 09/27/02 Saw that too, the bolt holes show evidence of being - YugoBernie (NoVA) 08:13:10 09/27/02 I just used a vice to push the pin back in. (n/m) - MikeH(Twin GT35BB Incon Z) 21:17:37 09/27/02
Post a Followup	You cannot reply to this message because you are not logged in.