Subject	inside>
Posted by	converted2+2 on September 07, 2002 at 8:46 PM
	This message has been viewed 49 times.
In Reply To	torque converts are sealed. Don't know how would fill it (n/m) posted by MikeH(Twin GT35BB Incon Z) on September 07, 2002 at 07:42 PM
Message	There really is no point in filling your torque converter with fluid. Unless you lost a whole bunch out of it I wouldnt worry about it. Just make sure you have an adequate amount in your tranny on start up. About those wires, I would hook every other plug up and the one that is left you will have to splice into. Hope this helps.
Follow Ups	Mystery Wire? and Autotrans/Torque Converter Question - LV-Z 19:39:02 09/07/02 torque converts are sealed. Don't know how would fill it (n/m) - MikeH(Twin GT35BB Incon Z) 19:42:58 09/07/02 inside> - converted2+2 20:46:00 09/07/02 But how would i know which wire to hook to? (n/m) - LV-Z 20:52:25 09/07/02 Re: 94 serv manual shows it as a oval connector>>> - nissanlord 21:27:01 09/07/02 Those two wires are from the speed sensor. - Zbra 08:25:07 09/08/02
Post a Followup	You cannot reply to this message because you are not logged in.