Subject	Looks good, about the difference in boost readings>>
Posted by	speedr300z (ATL) on September 03, 2002 at 11:32 PM
	This message has been viewed 54 times.
In Reply To	Painted my boost controller black - take a look posted by degradated on September 03, 2002 at 10:28 PM
Message	Is your Greddy dead on 0psi when off? The first Autometer that I received read -2 when it was off, thus causing an incorrect reading. Do they read the same in vacum? 1 line might be pinched a bit causing a different reading. Intercooler pressure drop should not be factor, if you have them both tapped into the manifold.
Follow Ups	Painted my boost controller black - take a look - degradated 22:28:44 09/03/02 Here's a "before" picture - degradated 22:31:57 09/03/02 What'd you do to keep paint out the crevices? (n/m) - U ZCREAM (Gainesville) 22:34:09 09/03/02 Re: What'd you do to keep paint out the crevices? - degradated 22:41:57 09/03/02 Looks good (n/m) - Eric339 22:41:07 09/03/02 Well with the evc iv i have an ofset adjustment> - Xi0nX4 (ohio) 22:43:59 09/03/02 Man, I love your car... - degradated 22:51:29 09/03/02 nice nice (n/m) - Neo Corleone 22:46:18 09/03/02 Nice job (n/m) - wesman [92TT-less ] 23:10:24 09/03/02 looks very good (n/m) - sbsTT(MD) 23:27:58 09/03/02 2nd (n/m) - Red Z Boy 4 23:31:48 09/03/02 Looks good, about the difference in boost readings>> - speedr300z (ATL) 23:32:21 09/03/02 Hmm...I'll check if any lines are pinched - degradated 23:39:05 09/03/02 Did you have your interiour done with leather? (n/m) - MikeH(Twin GT35BB Incon Z) 23:52:09 09/03/02 What do you mean? I have the factory leather that came with - degradated 01:06:15 09/04/02 Alright, I think I figured out why my BC shows higher boost - degradated 01:11:12 09/04/02 Errr... I don't see much of an improvement. (n/m) - teahead 20:05:41 09/04/02
Post a Followup	You cannot reply to this message because you are not logged in.