Subject	Painted my boost controller black - take a look
Posted by	degradated on September 03, 2002 at 10:28 PM
	This message has been viewed 477 times.
Message	The silver did not go with my whole all black theme, so I painted it with Vinyl flat black paint I found at Autozone. Came out pretty good. On a side note, I noticed that the boost controller shows about 1 full psi higher than my Greddy boost gauge does (posted in tech forum but haven't figured out why yet). Is this because of intercooler pressure drop? If so, which measurement should I really be looking at? I'm still waiting for my JWT ECU, so I'm keeping it under 12 psi according to the controller, although it only shows about 10.6 on my gauge, so can I bump it up a little bit? I'm at 12 Gain and around 40 Set, I believe.
Follow Ups	Painted my boost controller black - take a look - degradated 22:28:44 09/03/02 Here's a "before" picture - degradated 22:31:57 09/03/02 What'd you do to keep paint out the crevices? (n/m) - U ZCREAM (Gainesville) 22:34:09 09/03/02 Re: What'd you do to keep paint out the crevices? - degradated 22:41:57 09/03/02 Looks good (n/m) - Eric339 22:41:07 09/03/02 Well with the evc iv i have an ofset adjustment> - Xi0nX4 (ohio) 22:43:59 09/03/02 Man, I love your car... - degradated 22:51:29 09/03/02 nice nice (n/m) - Neo Corleone 22:46:18 09/03/02 Nice job (n/m) - wesman [92TT-less ] 23:10:24 09/03/02 looks very good (n/m) - sbsTT(MD) 23:27:58 09/03/02 2nd (n/m) - Red Z Boy 4 23:31:48 09/03/02 Looks good, about the difference in boost readings>> - speedr300z (ATL) 23:32:21 09/03/02 Hmm...I'll check if any lines are pinched - degradated 23:39:05 09/03/02 Did you have your interiour done with leather? (n/m) - MikeH(Twin GT35BB Incon Z) 23:52:09 09/03/02 What do you mean? I have the factory leather that came with - degradated 01:06:15 09/04/02 Alright, I think I figured out why my BC shows higher boost - degradated 01:11:12 09/04/02 Errr... I don't see much of an improvement. (n/m) - teahead 20:05:41 09/04/02
Post a Followup	You cannot reply to this message because you are not logged in.