Subject	There's a small fuse box by your left foot on the drivers
Posted by	degradated on September 03, 2002 at 7:24 PM
	This message has been viewed 181 times.
In Reply To	ok - I'm an electrical moron - can you be more specific? (n/m) posted by Furious(Houston) on September 03, 2002 at 07:16 PM
Message	side. Pull the black plastic cover, and look at the diagram. It will tell you which fuse is ignition. Just pop out that fuse with a pair of needle nose plyers, then strip the end of your wire and cram it in the hole where the fuse was. Then push the fuse back in so that the metal contacts are touching the wire and the contacts inside the box too. It might take a few times to get the wire positioned so the fuse will go all the way back in. That's it!
Follow Ups	boost gauge install question - ignition wire?? - Furious(Houston) 18:41:30 09/03/02 curious as to what you need the ignition wire for? (n/m) - speedr300z (ATL) 18:50:32 09/03/02 instructions say I need an ignition 12V source >>>> - Furious(Houston) 19:08:47 09/03/02 ahh, tap into a fuse in the fuse box.. (n/m) - speedr300z (ATL) 19:13:37 09/03/02 ok - I'm an electrical moron - can you be more specific? (n/m) - Furious(Houston) 19:16:51 09/03/02 There's a small fuse box by your left foot on the drivers - degradated 19:24:05 09/03/02 Stick wet finger on red wire :-) (n/m) - YugoBernie (NoVA) 19:26:00 09/03/02 Come up this weekend if you can't figure it out... - LordZ 19:50:05 09/03/02 Use a volt/ohm meter and start prodding , that is what - MikeH(Twin GT35BB Incon Z) 22:22:14 09/03/02
Post a Followup	You cannot reply to this message because you are not logged in.