Subject	ahh, tap into a fuse in the fuse box.. (n/m)
Posted by	speedr300z (ATL) on September 03, 2002 at 7:13 PM
	This message has been viewed 94 times.
In Reply To	instructions say I need an ignition 12V source >>>> posted by Furious(Houston) on September 03, 2002 at 07:08 PM
Message
Follow Ups	boost gauge install question - ignition wire?? - Furious(Houston) 18:41:30 09/03/02 curious as to what you need the ignition wire for? (n/m) - speedr300z (ATL) 18:50:32 09/03/02 instructions say I need an ignition 12V source >>>> - Furious(Houston) 19:08:47 09/03/02 ahh, tap into a fuse in the fuse box.. (n/m) - speedr300z (ATL) 19:13:37 09/03/02 ok - I'm an electrical moron - can you be more specific? (n/m) - Furious(Houston) 19:16:51 09/03/02 There's a small fuse box by your left foot on the drivers - degradated 19:24:05 09/03/02 Stick wet finger on red wire :-) (n/m) - YugoBernie (NoVA) 19:26:00 09/03/02 Come up this weekend if you can't figure it out... - LordZ 19:50:05 09/03/02 Use a volt/ohm meter and start prodding , that is what - MikeH(Twin GT35BB Incon Z) 22:22:14 09/03/02
Post a Followup	You cannot reply to this message because you are not logged in.