Subject	instructions say I need an ignition 12V source >>>>
Posted by	Furious(Houston) on September 03, 2002 at 7:08 PM
	This message has been viewed 140 times.
In Reply To	curious as to what you need the ignition wire for? (n/m) posted by speedr300z (ATL) on September 03, 2002 at 06:50 PM
Message	This gauge has an electrical harness - and I guess it needs power from somewhere. I also need the parking light to do the backlighting, but I think with the peak hold and warning and all that I need the ignition power source. What kind of drunk are you? "And Shepherds we shall be, for Thee my Lord, for Thee. Power hath descended forth from Thy hand that our feet may swiftly carry out Thy command. We shall flow a river forth unto Thee And teeming with souls shall it ever be. In nomine Patris, et Fili, et Spiritu Sancti."
Follow Ups	boost gauge install question - ignition wire?? - Furious(Houston) 18:41:30 09/03/02 curious as to what you need the ignition wire for? (n/m) - speedr300z (ATL) 18:50:32 09/03/02 instructions say I need an ignition 12V source >>>> - Furious(Houston) 19:08:47 09/03/02 ahh, tap into a fuse in the fuse box.. (n/m) - speedr300z (ATL) 19:13:37 09/03/02 ok - I'm an electrical moron - can you be more specific? (n/m) - Furious(Houston) 19:16:51 09/03/02 There's a small fuse box by your left foot on the drivers - degradated 19:24:05 09/03/02 Stick wet finger on red wire :-) (n/m) - YugoBernie (NoVA) 19:26:00 09/03/02 Come up this weekend if you can't figure it out... - LordZ 19:50:05 09/03/02 Use a volt/ohm meter and start prodding , that is what - MikeH(Twin GT35BB Incon Z) 22:22:14 09/03/02
Post a Followup	You cannot reply to this message because you are not logged in.