Subject	doubt they are leaking but.. screw in the bolt to make them
Posted by	Carlos Ramirez on August 22, 2002 at 8:05 PM
	This message has been viewed 34 times.
In Reply To	Where's the love. OK under boost I think my pass side posted by kingtut(So.Cal) on August 22, 2002 at 07:31 PM
Message	tighter. All that will do is cause them to not release until higher boost. Remember this a pull type BOV not a push type.
Follow Ups	HKS Blow off valves, how do you tighten them to stop leaking - kingtut(So.Cal) 18:43:25 08/22/02 Where's the love. OK under boost I think my pass side - kingtut(So.Cal) 19:31:49 08/22/02 doubt they are leaking but.. screw in the bolt to make them - Carlos Ramirez 20:05:32 08/22/02 Thank you sensei. (n/m) - kingtut(So.Cal) 20:09:07 08/22/02 HKS, pull type BOVs, don't leak. (n/m) - sparkie 08:25:20 08/23/02
Post a Followup	You cannot reply to this message because you are not logged in.