Subject	So why didn't you recommend this before??
Posted by	KaZ (jTTfz) NoVa on August 13, 2002 at 10:09 PM
	This message has been viewed 56 times.
In Reply To	Lemme guess... posted by SpdDemon13 (Baltimore) on August 13, 2002 at 09:19 PM
Message	When I was asking you what parts I should order if addition to what I already was? Hmmmm?? =) Its a thought I'll look into it. Later, KaZ KaZ (jspec Twin Turbo fairlady z) Northern Virginia - "Unique Z" Dyno'd - 339 RWHP / 369 RWTQ @ 17 TDC AIM - KaZsMiR / E-mail @ Hotmail - casimijg 20 Timing Belts, 5 Suspension Installs, 4 Engine Pulls, 3 Clutch Installs, 2 Rear Mains, 1 Pop Charger, 1 Koyo Installation and Counting...
Follow Ups	If I decide to replace head gaskets, what else should >>> - KaZ (jTTfz) NoVa 19:45:39 08/13/02 Water hoses under plenum and behind engine. (n/m) - Seb 19:53:05 08/13/02 Get the heads checked for straightness, HG do not blow for - Chip(GinnMotorsports) 19:55:04 08/13/02 you will be pulling the motor right? - Halo Z 19:57:22 08/13/02 I wish I had replaced the knock sensor while engine was out - Kez43 20:32:22 08/13/02 Have u tried bypassing it? (n/m) - Seb 21:13:40 08/13/02 no, got any links? just searched for 5 minutes with no luck - Kez43 22:28:54 08/13/02 u need to a 1 meg ohm resistor>>>>> - Seb 23:56:18 08/13/02 Thank you (n/m) - Kez43 10:03:26 08/14/02 Lemme guess... - SpdDemon13 (Baltimore) 21:19:38 08/13/02 i was waiting for a comment about posting that hidious - 3 double-0 ZX (Va Bch) 21:58:24 08/13/02 So why didn't you recommend this before?? - KaZ (jTTfz) NoVa 22:09:31 08/13/02 Excuse me??? Why do I have to be the one tell you? - SpdDemon13 (Baltimore) 00:06:04 08/14/02 damn right. (n/m) - thunderZ 00:09:21 08/14/02 And you... - KaZ (jTTfz) NoVa 07:06:17 08/14/02 Alright, for one thing, you take things way too seriously... - KaZ (jTTfz) NoVa 07:05:54 08/14/02 And you make way too many assumptions. - SpdDemon13 (Baltimore) 23:32:14 08/14/02 Why do you think it is your head gasket? (n/m) - SniPer SR71 (Dallas) 23:26:49 08/13/02
Post a Followup	You cannot reply to this message because you are not logged in.