TwinTurbo.NET: Nissan 300ZX forum - Just did the other day 140 on most cylinders >>>
People Seeking Info
 
   


     
Subject Just did the other day 140 on most cylinders >>>
     
Posted by KaZ (jTTfz) NoVa on August 13, 2002 at 7:04 PM
  This message has been viewed 32 times.
     
In Reply To Check compression, may be HG. posted by Chip(GinnMotorsports) on August 13, 2002 at 06:22 PM
     
Message 140-144 on #1, 2, 3, & 4... #5 & #6 were in the low 150s. But I could have sworn that #1-4 tested in the low 160 range a few months back, but #5 & #6 were similar results, around low 150s, high 140s.

Should I just put a stock HG in, or get a thicker aftermarket one like GReddy?

Later,
KaZ


KaZ (jspec Twin Turbo fairlady z) Northern Virginia - "Unique Z"
Dyno'd - 339 RWHP / 369 RWTQ @ 17 TDC
AIM - KaZsMiR / E-mail @ Hotmail - casimijg
20 Timing Belts, 5 Suspension Installs, 4 Engine Pulls, 3 Clutch Installs, 2 Rear Mains, 1 Pop Charger, 1 Koyo Installation and Counting...

East Coast Z32 Association

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.