Subject	Well, I tried to make sure >>>
Posted by	KaZ (jTTfz) NoVa on August 13, 2002 at 4:52 PM
	This message has been viewed 64 times.
In Reply To	Re: Interesting results after Koyo on hot day... (warn = bo posted by Dallas DamonZ on August 13, 2002 at 04:45 PM
Message	When it was filled yesterday... I did some high revs, with the heater on, all the things people have recommended to make sure the air is out of the system etc... And got as much coolant in as I could. Checked it this morning, and both sides were to the top, and wouldn't take any more coolant... I will check it again later and let you know. But I'd think if I was really low on coolant, it would have caused the air to expand and overflow the tank again... which it didn't. =( But you are a FAR more knowledgeable Z mechanic than I, and I ALWAYS, and I repeat, ALWAYS, appreciate your input. I'll check and let you know. Any other suggestions? Could a blown head gasket also be causing these issues? Thanks, KaZ KaZ (jspec Twin Turbo fairlady z) Northern Virginia - "Unique Z" Dyno'd - 339 RWHP / 369 RWTQ @ 17 TDC AIM - KaZsMiR / E-mail @ Hotmail - casimijg 20 Timing Belts, 5 Suspension Installs, 4 Engine Pulls, 3 Clutch Installs, 2 Rear Mains, 1 Pop Charger, 1 Set of Intercoolers, 1 Koyo Installation and Counting...
Follow Ups	Interesting results after Koyo on hot day... (warn = book) - KaZ (jTTfz) NoVa 16:33:28 08/13/02 Should have gotten the HOWE :P (n/m) - Snoguitar 16:40:28 08/13/02 Its not that much bigger... I think its just my Z >>> - KaZ (jTTfz) NoVa 16:42:25 08/13/02 Actually it probably would have. In 115 degree weather - wildstar 17:12:36 08/13/02 was waiting for you to post ;) (n/m) - Snoguitar 17:22:13 08/13/02 Well I'm not saying it wouldn't have completely not >>> - KaZ (jTTfz) NoVa 17:31:21 08/13/02 you just need a vented hood from strictlyZ - 3 double-0 ZX (Va Bch) 18:25:30 08/13/02 Don't think that is the answer, though it might help! (n/m) - KaZ (jTTfz) NoVa 22:14:21 08/13/02 Well... - wildstar 19:36:25 08/13/02 It actually is that much bigger >> - FNFAZTT 17:51:28 08/13/02 Re: Interesting results after Koyo on hot day... (warn = bo - Dallas DamonZ 16:45:42 08/13/02 Yes, possible that you got an air pocket in there. (n/m) - teahead 16:49:25 08/13/02 Well, I tried to make sure >>> - KaZ (jTTfz) NoVa 16:52:43 08/13/02 I removed the temp sensor to let air escape and I also - MikeH(Twin GT35BB Incon Z) 16:59:21 08/13/02 did you jack up the front end to get the air to the top - sbsTT(MD) 17:00:44 08/13/02 Yes, nose was about a foot or so in the air >>> - KaZ (jTTfz) NoVa 17:02:51 08/13/02 I'm with Damon on this - seen it happen with just >>> - Mike (Austin) 11:30:28 08/14/02 That the same behavior of my stock one. From observation - Arturo C. 16:51:05 08/13/02 Top is 232? You mean the mark "Below" H? >>> - KaZ (jTTfz) NoVa 16:57:55 08/13/02 could your water/antifeeze mix be a little lean? (n/m) - TonyD(90Z32TT) 16:51:44 08/13/02 Well, some recommended running completely water with wetter - KaZ (jTTfz) NoVa 16:54:45 08/13/02 took me 4 days to burp my cooling system - voodoo 17:00:05 08/13/02 you should have went 50/50 (n/m) - TARGETZ 18:14:01 08/13/02 50/50 is overkill, water actually does most of the cooling. (n/m) - Fly'n Z 18:23:50 08/13/02 nope... - TARGETZ 18:26:33 08/13/02 No it doesn't. (n/m) - wykked 19:28:16 08/13/02 Wrong. - Chip(GinnMotorsports) 19:39:12 08/13/02 you are wrong - aliaZ 22:38:08 08/13/02 Check compression, may be HG. - Chip(GinnMotorsports) 18:22:36 08/13/02 Just did the other day 140 on most cylinders >>> - KaZ (jTTfz) NoVa 19:04:47 08/13/02 Stock have been holding up fine to high boost, but - Chip(GinnMotorsports) 19:37:49 08/13/02 I bet chip is right on the mark. Could be a - Deca Z 18:54:23 08/13/02 Checked coolant level, right at the top >>. - KaZ (jTTfz) NoVa 19:08:56 08/13/02 Should have gotten the HOWE... (n/m) - Jake H 19:47:54 08/13/02 they never listen... (n/m) - HalfnHalf702(winner) 19:55:48 08/13/02 sure it's not just a screwy new temp sensor? - Altersys 20:24:13 08/13/02 thats what i was thinking (n/m) - Chris(NJ)=driveshaft king 21:18:43 08/13/02 What do you mean by the temp sensor exactly? - KaZ (jTTfz) NoVa 22:13:54 08/13/02 Re: What do you mean by the temp sensor exactly? - Altersys 12:40:47 08/14/02
Post a Followup	You cannot reply to this message because you are not logged in.