Subject	The outside edge where the cover bolts to the flywheel ....
Posted by	Specialty-Z on July 30, 2002 at 11:01 PM
	This message has been viewed 81 times.
In Reply To	So like turning a brake Rotor?? posted by Kyle (StrictlyZ.com) on July 30, 2002 at 10:26 PM
Message	should be machined down .010 more then the center where the disc runs...This procedure adds more clamping force, putting more holding pressure on the disc. They came stock with a .008 step and I like to put a .010 step in them. The RPS sport pressure plates has 200 lbs more clamping force then stock so you will be alright, But the 200 lbs extra clamping force rating is with a .008 step in the flywheel.
Follow Ups	Clutch install photos - Kyle (StrictlyZ.com) 21:44:51 07/30/02 From the photo it looks like your flywheel is cut flat... - Specialty-Z 22:01:07 07/30/02 where is the step supposed to be? (n/m) - 3 double-0 ZX (Va Bch) 22:17:51 07/30/02 your flywheel looks like it was machined wrong - aliaZ 22:10:57 07/30/02 How can you tell when its cut with a step?? (n/m) - Kyle (StrictlyZ.com) 22:17:00 07/30/02 It looks very noticeable and you can feel>>> - Seb 22:23:12 07/30/02 So like turning a brake Rotor?? - Kyle (StrictlyZ.com) 22:26:04 07/30/02 some details in TECH for clutch replacement (n/m) - Dallas DamonZ 22:39:33 07/30/02 The outside edge where the cover bolts to the flywheel .... - Specialty-Z 23:01:11 07/30/02 Thanks guys 2 more questions - Kyle (StrictlyZ.com) 00:26:03 07/31/02 Re: Thanks guys 2 more questions - Dallas DamonZ 08:03:45 07/31/02 Thanks Damon - Kyle (StrictlyZ.com) 23:25:10 07/31/02
Post a Followup	You cannot reply to this message because you are not logged in.