Subject	your flywheel looks like it was machined wrong
Posted by	aliaZ on July 30, 2002 at 10:10 PM
	This message has been viewed 69 times.
In Reply To	Clutch install photos posted by Kyle (StrictlyZ.com) on July 30, 2002 at 09:44 PM
Message	This will likely cause early clutch failure if not corrected. The clutch on my Z started slipping soon after I bought it (it was still stock). When I pulled the tranny I discovered that the clutch had been recently replaced, but the morons machined the flywheel flat instead of with a step, causing early failure.
Follow Ups	Clutch install photos - Kyle (StrictlyZ.com) 21:44:51 07/30/02 From the photo it looks like your flywheel is cut flat... - Specialty-Z 22:01:07 07/30/02 where is the step supposed to be? (n/m) - 3 double-0 ZX (Va Bch) 22:17:51 07/30/02 your flywheel looks like it was machined wrong - aliaZ 22:10:57 07/30/02 How can you tell when its cut with a step?? (n/m) - Kyle (StrictlyZ.com) 22:17:00 07/30/02 It looks very noticeable and you can feel>>> - Seb 22:23:12 07/30/02 So like turning a brake Rotor?? - Kyle (StrictlyZ.com) 22:26:04 07/30/02 some details in TECH for clutch replacement (n/m) - Dallas DamonZ 22:39:33 07/30/02 The outside edge where the cover bolts to the flywheel .... - Specialty-Z 23:01:11 07/30/02 Thanks guys 2 more questions - Kyle (StrictlyZ.com) 00:26:03 07/31/02 Re: Thanks guys 2 more questions - Dallas DamonZ 08:03:45 07/31/02 Thanks Damon - Kyle (StrictlyZ.com) 23:25:10 07/31/02
Post a Followup	You cannot reply to this message because you are not logged in.