Subject	just got hard pipes from group buy
Posted by	AvailPunk9 on July 30, 2002 at 8:45 PM
	This message has been viewed 102 times.
Message	couple of qs. which pipe goes where? the 2.5 45 degree goes on pass side and 2.5 30 degree drivers side rite? are there any templates or should i just eye ball it. woud home depo have rubber hoses to use as connectors or go somewhere else? finally. polishing question, my drill only goes up to like 2200 rpm is that enough to polish or should i find a faster one? it's looking ok but would like the mirror effect on the pipe. thanks guys
Follow Ups	just got hard pipes from group buy - AvailPunk9 20:45:00 07/30/02 Check AshsZ site. He posted some templates on there I think - boileralum00 20:58:37 07/30/02 Dont use those, they haven't been confirmed.. I've been - AshsZ (Fab Whore, Ph.D) 21:03:20 07/30/02 Sorry. I just saw the link in your news section when I was - boileralum00 21:09:13 07/30/02 Why weren't they pre-cut ? (n/m) - wesman [92TT-less ] 22:04:17 07/30/02 That is the fun with Ash-Fab-Whoring, you do all labor. - Chip(GinnMotorsports) 23:50:25 07/30/02 Well, lets talk about Chip-Ginn buying then. - AshsZ (Fab Whore, Ph.D) 07:25:55 07/31/02 I have no problem with labor, yes you did CLEARLY - Chip(GinnMotorsports) 17:56:44 07/31/02 EVERYONE in the GB realized the pipes werent cut, polished, - AshsZ (Fab Whore, Ph.D) 07:34:53 07/31/02 I was not complaining only pointing out the obvious. (n/m) - Chip(GinnMotorsports) 17:57:34 07/31/02 It was stated in the GB that they were just the pipes, uncut - AshsZ (Fab Whore, Ph.D) 07:18:01 07/31/02 Ash, most of us like all the Fab-whoring you do... - speedr300z 15:44:03 07/31/02 Agreed, if Ash would only relax some. (n/m) - Chip(GinnMotorsports) 17:58:21 07/31/02
Post a Followup	You cannot reply to this message because you are not logged in.