Subject	Thanks, I'm a moron... didn't read it thoroughly... (n/m)
Posted by	KaZ (jTTfz) NoVa on July 25, 2002 at 10:25 PM
	This message has been viewed 14 times.
In Reply To	the rods in the photo are from a honda (n/m) posted by z324u on July 25, 2002 at 09:35 PM
Message
Follow Ups	A few of my new Rods and Pistons (lots of pics) - Carlos Ramirez 19:08:20 07/25/02 How long did it take to get them? (n/m) - Goose93 19:13:17 07/25/02 rods were in stock. Pistons 2 weeks. (n/m) - Carlos Ramirez 19:21:24 07/25/02 $$? Bore, compression? >>> - KaZ (jTTfz) NoVa 19:35:03 07/25/02 Compression 8.55:1 and small over bore 87.5mm (n/m) - Carlos Ramirez 19:36:40 07/25/02 So did you raise or lower compression? And are the rods >>> - KaZ (jTTfz) NoVa 21:13:32 07/25/02 the rods in the photo are from a honda (n/m) - z324u 21:35:07 07/25/02 Thanks, I'm a moron... didn't read it thoroughly... (n/m) - KaZ (jTTfz) NoVa 22:25:39 07/25/02 Re: $$? Bore, compression? >>> - Carlos Ramirez 19:39:54 07/25/02 nice. - Halo Z 19:19:28 07/25/02 sweet. - J300ZTT (ATL) 19:23:56 07/25/02 nice, i am going with the same pistons thanks to your - z324u 21:31:40 07/25/02 Re: nice, i am going with the same pistons thanks to your - 92TurboZ 22:04:45 07/25/02 nice setup you have going :-) (n/m) - Carlos Ramirez 22:54:09 07/25/02
Post a Followup	You cannot reply to this message because you are not logged in.