Subject	so would it increase flow to weld the bung shut or to
Posted by	z324u on July 24, 2002 at 11:16 PM
	This message has been viewed 65 times.
In Reply To	Get a different exhaust manifold, stock kills #6 posted by Chip(GinnMotorsports) on July 24, 2002 at 10:37 PM
Message	put a cap bolt in it? i was just going to put a bolt in it and tack weld the bolt, then grind down the end of the bolt inside the manifold flush and polish it. would that be better?
Follow Ups	Man I blew a Piston. - ZRO 22:00:03 07/24/02 At least 550RWHP is somewhat easy. It's how far OVER you - SeedyRom 22:06:01 07/24/02 yep, $$$$ is ALWAYS the limiting factor. (n/m) - spotz 22:15:43 07/24/02 550 is possible on 2530's, several have done it. - spotz 22:15:01 07/24/02 You can't go wrong with the Greddy kit - MikeH(Twin GT35BB Incon Z) 22:24:08 07/24/02 I am going td-05s for my rebuild, good hunk of $$ (n/m) - CB300ZXTT(FL) 22:25:44 07/24/02 TD04-16G's will make killer power. :) (n/m) - AshsZ (Fab Whore, Ph.D) 08:54:03 07/25/02 Get a different exhaust manifold, stock kills #6 - Chip(GinnMotorsports) 22:37:48 07/24/02 yea well getting the greddy kit from you hopefully.. - CB300ZXTT(FL) 22:40:53 07/24/02 so would it increase flow to weld the bung shut or to - z324u 23:16:15 07/24/02 nevermind, just remembered what the hole looks like. it has - z324u 23:48:34 07/24/02 I put a pipe plug on my exhaust manifold for the - MikeH(Twin GT35BB Incon Z) 23:50:39 07/24/02 thanks - z324u 23:15:35 07/25/02 I don't trust steallin to put the parts in that they say are - kingtut(So.Cal) 23:36:25 07/24/02 center, point guard, who?????? (n/m) - Furious(Houston) 23:56:10 07/24/02 roflmao! (n/m) - AshsZ (Fab Whore, Ph.D) 08:53:08 07/25/02 re: - stupidfast 09:59:33 07/25/02
Post a Followup	You cannot reply to this message because you are not logged in.