Subject	If anyone is interested in a 3 pod a-pillar replacement>>>
Posted by	Mal1ce on October 24, 2000 at 4:45 PM
	This message has been viewed 13 times.
Message	setup, I may be able to set something up. So far I don't know of a company that makes a 3 pod a-pillar replacement for the Z. Right now you hafta get a dual and a single and cobble them togeather. The place I talked to said depending on interest they may be able to do something for us. This is very preliminary right now, just looking for who may be interested. I think aprox cost would be in the $40 to $50 range and the pods would accomidate up to a 60mm gauge. Thanks ============================================================================ Money??? I dont know what money is, I own a Z.
Follow Ups	If anyone is interested in a 3 pod a-pillar replacement>>> - Mal1ce 16:45:32 10/24/00 What about the DIN 3 gauge pod? - Maximamike™ 16:48:00 10/24/00 Is that a-pillar or over the dash? (n/m) - Mal1ce 16:50:02 10/24/00 That one only fits 46mm HKS gauges, so options are limited (n/m) - unlimitedZ [Patrick] 16:51:42 10/24/00 Sure. I'd be interested. Boost, Volt, and Fuel Press. (n/m) - teahead 17:55:15 10/24/00 i am interested. (n/m) - aZiator 18:19:24 10/24/00 I would be interested.. (n/m) - Carlos Ramirez 19:12:17 10/24/00 Put me in for one. (n/m) - Cruzes1 19:14:51 10/24/00 Interested... (n/m) - CatDaddy(OKC) 19:32:13 10/24/00 I'd think about it too (n/m) - Altered BeaZTT 20:03:13 10/24/00 I am interested. (n/m) - ZXTwnT300 07:16:25 10/25/00 I am interested... (n/m) - twinz 07:39:38 10/25/00
Post a Followup	You cannot reply to this message because you are not logged in.