Subject	Finishing up on my R34 Turbo install, have a couple Q's
Posted by	Zbra on July 11, 2002 at 8:45 PM
	This message has been viewed 161 times.
Message	How hot does the turbo exhaust housing get? I'm asking becuase the R34 exhaust housing has a different flange pattern than my stock turbos so I need to have a gasket cut for it. I'm looking for a hi temp type gasket material that I can cut and use because autozone sells some that's rated at 600 degrees and I'm not sure if that's high enough. Also I have an exhaust temp probe I'm having welded into the manifold, is there any certain place that I need to have this installed on the driver side manifold? Just wondering because I plan on having it placed on the side of the egr tube that enters the manifold.
Follow Ups	Finishing up on my R34 Turbo install, have a couple Q's - Zbra 20:45:16 07/11/02 900 C., very hot. - Chip(GinnMotorsports) 20:49:25 07/11/02 jb's! (n/m) - Halo Z 20:56:32 07/11/02 Its not the end all solution you think... =) (n/m) - KaZ (jTTfz) NoVa 21:25:10 07/11/02 Or is it... =) (n/m) - KaZ (jTTfz) NoVa 21:25:46 07/11/02 keem me updated, i gonna start mine in a few weeks - cheezoto(now w/ ECU) 21:37:19 07/11/02 I had copper gaskets made .060" thick (n/m) - MikeH(Twin GT35BB Incon Z) 22:54:53 07/11/02
Post a Followup	You cannot reply to this message because you are not logged in.