Subject	Well...
Posted by	Dallas DamonZ on October 23, 2000 at 5:39 PM
	This message has been viewed 22 times.
In Reply To	I don't like the pattern I'm seeing here... posted by ModernRonin on October 23, 2000 at 04:51 PM
Message	I never could find a torque spec in the service manual on it when I put together my page. Someone pointed out I still had my X ft-lbs. listed in the page a few months back. A couple people discussed what would be appropriate torque amounts for an aluminum fitting.. we came up with like 12 ft-lbs. Doesn't seem too outrageous to me, so I went with it. Not sure what's going on here tho. :-( I don't think I ever found one for the spark plug coil packs either... Later ``As long as I'm alive, I'm a little illegal.''
Follow Ups	I am looking for pics of the engine w/out the plenum - PLEAZURE in CA 12:59:50 10/23/00 What are you trying to do? >>> - Greg (Dallas) 13:04:37 10/23/00 I have a few pic's of a bare zx engine. E-mail me if u wanit (n/m) - TRUOMEGA 13:31:14 10/23/00 Re: What are you trying to do? >>> - PLEAZURE in CA 15:23:11 10/23/00 i was just looking at one about an hour ago. - HALO Z(GA) 13:48:33 10/23/00 here you go... pics of my engine during buildup... - Bernie 14:43:25 10/23/00 That's one yummy motor. (n/m) - ZHOUND 15:01:39 10/23/00 THANKS SOOO MUCH ...that's exactly what I needed !! (n/m) - PLEAZURE in CA 15:25:12 10/23/00 Beautiful engine dude. :-) (n/m) - Grec (East Bay, CA) 15:42:34 10/23/00 nice pics (n/m) - carlos(Oklahoma)-91NA 2+2 17:18:57 10/23/00 I don't like the pattern I'm seeing here... - ModernRonin 16:51:42 10/23/00 Well... - Dallas DamonZ 17:39:50 10/23/00 PLeeeasse remove the torque spec from the write-up, instead> - PLEAZURE in CA 17:45:37 10/23/00
Post a Followup	You cannot reply to this message because you are not logged in.