TwinTurbo.NET: Nissan 300ZX forum - Huge thanks to Kyle for correcting me and for the PICS!>>
People Seeking Info
 
   


     
Subject Huge thanks to Kyle for correcting me and for the PICS!>>
     
Posted by AshsZ (Fab Whore, Ph.D) on July 03, 2002 at 1:58 PM
  This message has been viewed 200 times.
     
     
Message Kyle, I do appreciate your determinism in setting the record straight. I'm still cleaning the egg off my face. :)
My deepest apologies are sent your way as well to Fred.

I have ordered a TT pump as well as all new bottom end bearings just in case. The engine ran fine, no knocks or ticks and pushing 50-60psi consistently. It handled 20psi quite well too. But I figure for the low cost of new bearings I may as well change them out while I'm in there and check to see how worn they are after 7000 miles.

I favorably admit when I am wrong, I dont carry my ass on my shoulders as many of you get the impression of. Its rather easy to jump the gun on this kind of communication interface (internet forums) as so much is lost as far as tone, etc. Tact almost seems to go with the wind.

But again, thanks for the correction, you guys definately went the extra mile to set the record straight and all of us will benefit from this.



[ ashleypowers.com ]
[ agpowers@bellsouth.net ]

When pigs dance, you better get it on video...

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.