Subject	2 ~120 degree 2.5" bends and 2 2.5-3" transition
Posted by	Chip(GinnMotorsports) on June 27, 2002 at 3:39 PM
	This message has been viewed 33 times.
In Reply To	I am looking for the two elbows for the twinpop posted by govaardz(Aruba) on June 27, 2002 at 10:26 AM
Message	connectors. Done. That is if you have the dummy MAF pipe, if not cheaper to get another MAF.
Follow Ups	I am looking for the two elbows for the twinpop - govaardz(Aruba) 10:26:26 06/27/02 Lol, good luck. I have been asking/searching for months. - Woody75 (Denver) 10:34:41 06/27/02 They won't even sell the bends if >> - SlicktopTT 11:18:48 06/27/02 I tried to buy just the bends and was told >>> - Woody75 (Denver) 12:36:38 06/27/02 They told me the same about the drivability kit >> - wesman [92TT-less ] 14:15:20 06/27/02 Stillen Did that to me with my Short throw when I broke it. - MugenRacer 14:15:27 06/27/02 I might be selling mine email me (n/m) - MikeH(Twin GT35BB Incon Z) 11:06:02 06/27/02 try the wide selection of PCV piping - cheezoto(now w/ CAMS) 11:19:11 06/27/02 Looks like the mechanic owes him a New Dual pop setup. (n/m) - MugenRacer 14:15:13 06/27/02 2 ~120 degree 2.5" bends and 2 2.5-3" transition - Chip(GinnMotorsports) 15:39:44 06/27/02
Post a Followup	You cannot reply to this message because you are not logged in.