Subject	jig. molds are for casting. (n/m)
Posted by	MugenRacer on June 19, 2002 at 12:18 PM
	This message has been viewed 17 times.
In Reply To	must be made out of a pentroofmold posted by govaardz(Aruba) on June 19, 2002 at 11:44 AM
Message
Follow Ups	Daymn, has NE1 seen this??? - sparkie 10:13:57 06/19/02 Look a lot like the Pentroof manifolds. (n/m) - JaimeZX™ 10:18:58 06/19/02 It's not hard to copy them if you have the tools and ability - MugenRacer 11:27:49 06/19/02 must be made out of a pentroofmold - govaardz(Aruba) 11:44:17 06/19/02 jig. molds are for casting. (n/m) - MugenRacer 12:18:30 06/19/02 very close but id still stick with the pentroof (n/m) - NISSAN_300ZXTT 15:01:27 06/19/02 Is that a dent in the bottom pic? 2nd to the right bottom> - Fokker 15:05:49 06/19/02 They are indented by designe for fitment (n/m) - NONE 16:49:00 06/19/02 Actually they are made from 321 Stainless better than - Carlos Ramirez 16:42:02 06/19/02 lol... whoops, someone wasted some money (n/m) - joel(PA) 16:45:13 06/19/02 You mean Pentroof mani. isn't stainless 321? - timz 18:15:08 06/19/02 nope its think 304 Stainless... (n/m) - Carlos Ramirez 18:19:48 06/19/02
Post a Followup	You cannot reply to this message because you are not logged in.