Subject	Volt, Water, and NOS...pic inside:
Posted by	Cruzes1 on October 19, 2000 at 6:07 PM
	This message has been viewed 21 times.
In Reply To	What 3 gauges would a NAZ utilize? (n/m) posted by MidnightZ on October 19, 2000 at 04:47 PM
Message	Here's what I did with my setup. I used 3 Autometer gauges custom fitted to a carbon fiber panel and covered with plexiglass. ...Later, [ECruz]
Follow Ups	Is there a 3-gauge DIN panel available for the Z? - unlimitedZ [Patrick] 15:52:40 10/19/00 Yes, HKS>>(pic)>> - Coz(Chicago) 15:57:56 10/19/00 Thanks Coz. Knew I had seen 1 but forgot where. (n/m) - unlimitedZ [Patrick] 16:05:36 10/19/00 hey coz, can that be modified to fit >> - amp26 16:52:07 10/19/00 You can make your own out of sheet plastic (n/m) - MikeH(Phoenix) 17:28:06 10/19/00 i wanted to do that, but i couldn't find a source >> - amp26 17:41:20 10/19/00 Go to a stereo install shop they sell the stuff (n/m) - MikeH(Phoenix) 17:44:13 10/19/00 You can also get ABS sheets from www.partsexpress.com (n/m) - kZtt 17:49:34 10/19/00 Good website, all kinds of stuff (n/m) - MikeH(Phoenix) 18:05:42 10/19/00 I used Lexan from a home improvement store - TelZX 18:22:33 10/19/00 What 3 gauges would a NAZ utilize? (n/m) - MidnightZ 16:47:31 10/19/00 water temp, EGT and air/fuel ratio (n/m) - UZI 16:53:13 10/19/00 That would be 4. 2 egt's ,one for each side (n/m) - Chris (NJ) 18:48:39 10/19/00 can use one if you toggle it and read 1 @ a time - toyluvr 18:51:32 10/19/00 volts,water, and ummm a/f maybe=-) (n/m) - HALO Z(GA) 16:53:38 10/19/00 Volt, Water, and NOS...pic inside: - Cruzes1 18:07:13 10/19/00 what happened to your temp gauge??? (n/m) - Mr.TT 18:10:01 10/19/00 Lost that little stopper, gotta find another one. - Cruzes1 18:19:30 10/19/00 Nice. where can I get a Navan shifter like that? (n/m) - teahead 18:24:35 10/19/00 volts, vacumn, trans fluid temp (auto) is goal for me (n/m) - toyluvr 18:49:32 10/19/00
Post a Followup	You cannot reply to this message because you are not logged in.