Subject	Just route the necessary wires and poke them...
Posted by	Jake H on June 05, 2002 at 9:34 PM
	This message has been viewed 25 times.
In Reply To	Fine, but be careful... posted by Jackie Chan (Boosted) on June 05, 2002 at 09:27 PM
Message	through the hole you drill in your pillar,then install the gauge pod,that way you won't have to take it off again.I have the same setup and I just left the wires hang there until the next weekend when my patience and desire returned.
Follow Ups	Question for those with AutoMeter pillar pods... - Jackie Chan (Boosted) 21:05:33 06/05/02 Re: Question for those with AutoMeter pillar pods... - Seb 21:12:25 06/05/02 Predrill? Waddya mean? (n/m) - Jackie Chan (Boosted) 21:26:13 06/05/02 pre=before. drill=drill (n/m) - intol 01:01:18 06/06/02 yes - genic 21:13:26 06/05/02 Dude - Jackie Chan (Boosted) 21:18:32 06/05/02 I'd like to borrow your poker when your done with it. (n/m) - nixit(dallas) 21:20:36 06/05/02 Fine, but be careful... - Jackie Chan (Boosted) 21:27:07 06/05/02 no, it's for my eyes. see my post below. (elec. shiznit) (n/m) - nixit(dallas) 21:29:41 06/05/02 Just route the necessary wires and poke them... - Jake H 21:34:34 06/05/02 I'm one up on you now Corey, i installed my ECU today;) - 350Z 21:38:13 06/05/02 WOW>.. i remember the days :-) - Z 6370 (Fab Hoe) 22:02:37 06/05/02 Damn shit - Jackie Chan (Boosted) 14:45:46 06/06/02 Kinda...not really - jayZbird 00:27:12 06/06/02
Post a Followup	You cannot reply to this message because you are not logged in.