TwinTurbo.NET: Nissan 300ZX forum - Kyle.
People Seeking Info
 
   


     
Subject Kyle.
     
Posted by ZHOUND on May 22, 2002 at 5:16 PM
  This message has been viewed 107 times.
     
In Reply To Nice numbers---> posted by Kyle(Houston) on May 22, 2002 at 04:54 PM
     
Message I was going to call you yestereday about this but then I got too busy. Anyway, the wastegates are tightened down all the way. I recorded a few runs at the track and the boost is definately not stable at above 22psi. The needle gets to 25 lbs but then backs off and fluctuates a little. Wonder if the avc-r is doing more than its supposed to?


: If you adjust the wastegates down you should not have problems with boost. I ran 25 Lbs all day long with Yacoub's car and Mike runs 24 Lbs steady on his car without any problems. Are you trying to set the controller on the dyno?? If so that is another problem. High boost can not be set on the dyno because the load is not enough.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.