Subject	Rebuilding engine...recommendation on rings, other stuff?
Posted by	unlimitedZ [Patrick] on October 12, 2000 at 3:07 PM
	This message has been viewed 35 times.
Message	I'm going to do a ring job while the motor is out for turbos. I've heard good things about Total Seal rings. Any comments? Also I'm doing some headwork (cams, valve springs, port & polish, etc). Anything else I should look at dooing, as far as internal preventative stuff? Gaskets, seals, whatever?
Follow Ups	Rebuilding engine...recommendation on rings, other stuff? - unlimitedZ [Patrick] 15:07:06 10/12/00 Nissan makes a gasket "kit" that is a good investment>>> - Mal1ce 15:14:04 10/12/00 ........also >>> - Mal1ce 15:26:15 10/12/00 ....and the det sensor. Replace that also if you can. (n/m) - Mal1ce 15:32:38 10/12/00 Klevite bearings and total seal ring. - 96-2+2TT (CONVERSION) 16:42:37 10/12/00 Who carries Klevite? (n/m) - unlimitedZ [Patrick] 18:08:18 10/12/00 So what exactly are your plans for that car?? (n/m) - Carlos Ramirez 17:15:53 10/12/00 Check my profile :-) (n/m) - unlimitedZ [Patrick] 18:07:51 10/12/00
Post a Followup	You cannot reply to this message because you are not logged in.