TwinTurbo.NET: Nissan 300ZX forum - Bad idea to do it that way.
People Seeking Info
 
   


     
Subject Bad idea to do it that way.
     
Posted by AshsZ (Fab Whore, Ph.D) on April 03, 2002 at 7:15 AM
  This message has been viewed 112 times.
     
In Reply To i converted my stock Retrics to BOVs for free posted by cheezoto(now w/ CAMS) on April 03, 2002 at 01:59 AM
     
Message cuz it will make the engine run lean. When you are cruising, the recirc is actually open and that opening in the recirc will allow air to enter the intake tract at that point as it is lesser resistance than pulling it through the MAS. You will run lean during moderate throttle cruises. If you want to REALLY convert your recircs to BOVs, here's how you do it. >>
[ http://ashleypowers.com/Image%20Gallery/Recirc-BOV/index.htm ]

This way they stay closed at idle and only open when the pressure differential before and after the torottle body is large (i.e. when you are boosting hard and let off the gas).


: and they sounded about as loud as the HKS, just disconnect the rubber hoses from your intake pipes, pug up the holes and then put caps over the rubber hoses with a small hole drilled in the center of the cap, if your idle is rough then you made the hole too big. Other than that the bigger the hole the louder the noise, go as big as you can before your idle starts flucutating.

: They sound good :)

My CarPuter Headquarters

[ ashleypowers.com ]
[ agpowers@bellsouth.net ]

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.