Subject	Charlie you have a service manual right?>>>
Posted by	NVMYZTT on October 10, 2000 at 2:46 PM
	This message has been viewed 14 times.
In Reply To	Well, I have joined the ranks of Wolf, MikeH, etc.... posted by Mal1ce on October 10, 2000 at 12:46 PM
Message	First of all you need new headgaskets...you can't reuse them. Either get stock or spend the $500 or so for some Greddy metal head gaskets. Then make sure you torque the heads down to spec like the service manual says.... tighten, loosen, and then retighten...and the first torquing of the heads is not as tight as the final torque figures... I think it's first like 30 lbs. then loosen then tighten to 90 lbs... I can't remember, check the service manual. 95TT Black/Black 5 speed Future DSP project car
Follow Ups	Well, I have joined the ranks of Wolf, MikeH, etc.... - Mal1ce 12:46:54 10/10/00 hope it won't be too cold tonite to work on it! Need - FLY 1 (DallaZ) 12:54:58 10/10/00 Sounds good man, did you get my e-mail on Howe? I know >>>> - ZBlacktt 12:57:51 10/10/00 Re: Good luck, it's pretty straight fwd, torque to specs. (n/m) - Wolf [Pittsburgh] 13:08:02 10/10/00 Charlie you have a service manual right?>>> - NVMYZTT 14:46:15 10/10/00
Post a Followup	You cannot reply to this message because you are not logged in.