Subject	Its hard to say. I handtightened it and it will >>>>>>>>
Posted by	CRuNK™ on March 19, 2002 at 6:51 PM
	This message has been viewed 25 times.
In Reply To	Thread the bolt into the rail and see how it lines up? posted by N/A-ZTY on March 19, 2002 at 06:23 PM
Message	line up at an off angle, but that aluminum is going to give quite a bit even with light torque, so It's hard to say.
Follow Ups	Has anyone seen this kind of fuel fitting in a Border kit? - CRuNK™ 17:15:21 03/19/02 no copper washers? you would think it would leak - TARGETZ 17:54:32 03/19/02 I have copper washers, but it still bothers me. Are there>>> - CRuNK™ 18:54:07 03/19/02 I would look into them maybe more flow less resistance (n/m) - TARGETZ 23:15:41 03/19/02 I used banjo fittings on the oil lines on my turbos because - MikeH(Twin GT35BB Incon Z) 00:46:18 03/20/02 Thread the bolt into the rail and see how it lines up? - N/A-ZTY 18:23:40 03/19/02 Its hard to say. I handtightened it and it will >>>>>>>> - CRuNK™ 18:51:14 03/19/02 That definitely would leak w/o sealing washers... - Dave (CA) 18:34:36 03/19/02
Post a Followup	You cannot reply to this message because you are not logged in.