Subject	are you have blow out? Is your gap around .34 or so?
Posted by	Carlos Ramirez on March 17, 2002 at 9:01 PM
	This message has been viewed 51 times.
In Reply To	2 things: posted by SactoTodd on March 17, 2002 at 08:42 PM
Message	: Are you using a Air/Fuel gauge, or your carputer? : Check this site out, it says that a air/fuel gauge will read full rich at WOT. : [ http://www.gadgetseller.com/ ] : Note: this site was posted on THIS board awhile back. : : Also, as boost increases, there is a chance that the boost will actually blow out the spark. Hence, the gap is made smaller as boost goes up. I don't know of a formula. Again, this is my understanding. : With my 323, the stock gap at 9 lbs of boost is 1.1 mm, while a gap of 0.7 mm is used at 15 lbs, also with colder plugs. Again, over at the 323 board, when people ask about a miss at high boost/rpms, people always recommend a smaller gap. Make it smaller, then give it a run. :) : Good luck, and I hope this helps!
Follow Ups	I joined the darkside and now my powers are growing!>>> - AshsZ (Fab Whore, Ph.D) 19:29:58 03/17/02 What did the conversion cost you? (n/m) - 91FaIrLaDyZ 19:35:20 03/17/02 ever try his website? oh, your that lazy guy. (n/m) - nixit 19:38:39 03/17/02 DOH. the dude's marked/ (n/m) - HaloZ• 19:47:08 03/17/02 $3960 (n/m) - 91FaIrLaDyZ 19:48:24 03/17/02 Not "your", YOU'RE...YOU ARE :) (n/m) - Hamid the TranceSender 08:06:47 03/18/02 TT coil packs? (n/m) - nixit 19:37:38 03/17/02 They're the same.. (n/m) - AshsZ (Fab Whore, Ph.D) 20:03:44 03/17/02 2 things: - SactoTodd 20:42:36 03/17/02 are you have blow out? Is your gap around .34 or so? - Carlos Ramirez 21:01:45 03/17/02 Sounds like a plan to me. Thanks Bro!!! >>> - AshsZ (Fab Whore, Ph.D) 21:17:14 03/17/02 This sounds too basic, but I'd try swapping in a new PTU> - mtbakesz 20:44:08 03/17/02 It didn't do this at 7psi. Can't be that. Gotta be plugs.>> - AshsZ (Fab Whore, Ph.D) 21:25:35 03/17/02 2 things>>>>> - SWEET Z 21:36:00 03/17/02 Thanks for the input, gotta couple Q's? - AshsZ (Fab Whore, Ph.D) 22:05:43 03/17/02 It is a common knowledge, on how compression ratio's are - SWEET Z 23:28:28 03/17/02 LOL, bro, I'm leaps and bounds beyond you >>> - AshsZ (Fab Whore, Ph.D) 06:34:13 03/18/02 reset ecu, install TT #6, gap at .035. (n/m) - thunderZ 00:37:54 03/18/02 my 86 turbo would hesitate like yours - Marshall 23:39:54 03/17/02
Post a Followup	You cannot reply to this message because you are not logged in.