Subject	Fyi on border fuel rails>>>>>
Posted by	CRuNK™ on March 14, 2002 at 10:39 PM
	This message has been viewed 89 times.
Message	To those of you who get border fuel rails, be sure to check down the rail and make sure it's clean. There seems to be some leftover aluminum bits from the machining that are in the rail,. To those of you who play with guns it gives the appearance of a slightly fouled barrel, Its no big deal , I just didn't figure anyone would want a chunk of aluminum trying to push through a brand new injector, I dont buy or install aftermarket fuel rails on a regular basis so I dont know if this is a normal thing, I am guessing i can just blow it out with some compressed air, It doesn't look like it is still attached to anything, just a few leftover bits.
Follow Ups	Fyi on border fuel rails>>>>> - CRuNK™ 22:39:53 03/14/02 $1200? was that it? lol (n/m) - ZBlacktt 23:04:54 03/14/02 keep guessing, I'll never tell.lol (n/m) - CRuNK™ 23:42:25 03/14/02
Post a Followup	You cannot reply to this message because you are not logged in.