TwinTurbo.NET: Nissan 300ZX forum - Re: I'd say it's his parts used....
People Seeking Info
 
   


     
Subject Re: I'd say it's his parts used....
     
Posted by Marshall on March 13, 2002 at 4:53 PM
  This message has been viewed 35 times.
     
In Reply To I'd say it's his parts used.... posted by ZBlacktt on March 13, 2002 at 02:26 PM
     
Message That 8k rpm rev limiter does nothing for him. Look at his HP and torque, his torque is higher than the HP, this means his torque is peaking before 5250 rpm, there's no way that he's going to get more power revving to 8000 rpm. His power is going to be dropping after 6000 rpm. Even though he probably modded his engine so it can breathe well at high RPM's, the engine as it is now has the power peaking at a relatively low (for a modded Z)RPM. This isn't a bad thing, with that lower end torque the driveability will be better and it has loads of torque.


:being backed up with a 3.2 liter motor and a 8k rpm rev limiter, extrudeHoned manifolds, Bored TB's etc,etc, so he's got much room to move air.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.