TwinTurbo.NET: Nissan 300ZX forum - Clutch, flywheel, starter, and subframe spacers
People Seeking Info
 
   


     
Subject Clutch, flywheel, starter, and subframe spacers
     
Posted by F8IZHIS on February 09, 2002 at 1:26 AM
  This message has been viewed 86 times.
     
In Reply To I was planning on dropping by, but decided>>>> posted by Seb on February 09, 2002 at 01:17 AM
     
Message It was grinding every so often when I would start it, and was becoming more frequent. So, I figured it was time to replace the flywheel. My clutch didn't really slip on me unless I dragged the car (like in Bakersfield). When we got the clutch and flywheel out, the flywheel had heat cracks all over the place (I took pictures) and the clutch was down to the rivets. The starter was checked and appeared fine. Everything at that point was popped back together. I tried to start it a few times and it made that grinding noise again. So I went with a used starter, works great now. The 13 lb. flywheel is definitely noticeable, and looks cool too.








     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.