Subject	i wouldn't go that far....
Posted by	richk on February 06, 2002 at 11:58 AM
	This message has been viewed 74 times.
In Reply To	The post should be called Engine Rebuilding for Dummys LOL! (n/m) posted by MikeH(Twin GT35BB Incon Z) on February 06, 2002 at 11:38 AM
Message	ash did pick a bad spot to put himself in. but his attitude and question about the rod bearing sizes doesn't lend itself to making him sound like he's comfortable doing this job. needs to remember to slow down and be methodical regardless of when this guy needs his motor. I'd rather get my motor late than get it broke. rich '91 300ZXTT "Stage 2.5 10psi" 298.5RWHP / 302.5FT-LBS 13.48 @ 105.65 Z32.org
Follow Ups	Engine Rebuild 101: The saga continues! >>> - AshsZ (LUMBRJCK) 08:01:54 02/06/02 u sure its the water pump? - TRUOMEGA 08:12:11 02/06/02 Yeah, the fan wasn't even attached. Pulley just bolted on. (n/m) - AshsZ (LUMBRJCK) 08:22:36 02/06/02 only time will show the wrong size..I would still replace> - Russ ZTT (Back in Bidness) 09:34:13 02/06/02 You guys need to work on your trouble shooting skills :) - Cravin 09:47:18 02/06/02 duh! if the bearings are too small that won't cause - MikeH(Twin GT35BB Incon Z) 10:07:23 02/06/02 I think once load is increased on those rods >>> - wesman [92TT-less ] 09:51:27 02/06/02 I agree. The fit maybe OK now, but at operating temperature - Gordo 93TT NYC 10:22:30 02/06/02 I think you should stick to electronic gizmos and leave the - MikeH(Twin GT35BB Incon Z) 10:11:48 02/06/02 Lets JUST GET some SHIT straight here! >>> - AshsZ (LUMBRJCK) 10:39:53 02/06/02 Are you saying you did all the machine work and - MikeH(Twin GT35BB Incon Z) 10:51:20 02/06/02 Hehehe.. No, I didn't balance it myself. :) >>> - AshsZ (LUMBRJCK) 13:02:53 02/06/02 Hehehe...these are the same injectors you were >> - wesman [92TT-less ] 17:19:51 02/06/02 Re: Lets JUST GET some SHIT straight here! >>> - richk 11:17:24 02/06/02 The post should be called Engine Rebuilding for Dummys LOL! (n/m) - MikeH(Twin GT35BB Incon Z) 11:38:42 02/06/02 i wouldn't go that far.... - richk 11:58:35 02/06/02 LOL, the exact thoughts went through my mind as I wrote it. - AshsZ (LUMBRJCK) 12:18:06 02/06/02 dude i think AshsZ Knows what the hell hes doing! (n/m) - MBS103 15:43:00 02/06/02 if you guys are smart you will still change the bearings (n/m) - FANTAZ 11:16:26 02/06/02
Post a Followup	You cannot reply to this message because you are not logged in.