TwinTurbo.NET: Nissan 300ZX forum - The tilton clutch should hold up fine for the Z and is very
People Seeking Info
 
   


     
Subject The tilton clutch should hold up fine for the Z and is very
     
Posted by TwinTurboPete on January 29, 2002 at 9:56 PM
  This message has been viewed 74 times.
     
In Reply To from an EX Z owner, current supra owner posted by albert [Van,BC] on January 29, 2002 at 09:05 PM
     
Message driveable.


: Most of the oldtimers here on tt.net will remember my car. My goal was to run low 11's on a stock bottom end but that didn't happen. It turned out that my motor got weaker and weaker, I could never get close to that goal. Anyways, the biggest problem with the Z is traction. With drag radials I couldn't get anything better than 1.9sec short times without destroying one of the best clutches on the market for the Z at that time. And still today, there isn't a clutch for the Z that'll allow 7k rpm slip launches all day long, like the supra has.

: Ok on my supra, I have a stock toyota clutch that withstands 5k lauches. I have over 100runs on this stock clutch at BPU. So far my best time is 11.8@121mph. The advantage is the short time. Also, the other OEM components that I have that the Z doesn't (larger injectors).

: A properly tuned BPU should run 11's with drag radials. I've only invested $1000cdn in mine. Most Z's at stage V have 3 times invested and still barely muster 12's.

: I wont argue beyond that. MOney is the figure that makes your car fast. Beyond stage X, or APU anything goes. The costs including the cars are relatively close.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.