Subject	Ours is exactly the oposite. bolts to diff. and slides into
Posted by	PiotrC70 on January 20, 2002 at 7:32 PM
	This message has been viewed 20 times.
In Reply To	Mine bolts directly to tranny and doesn't slide into it. posted by TT6SPD95 on January 20, 2002 at 07:21 PM
Message	the tranny. "Do not allow yourself to get attached to anything that you cannot walk out of in 30 seconds flat when you spot the heat coming around the corner"
Follow Ups	carbon fiber driveshaft - TT6SPD95 18:32:02 01/20/02 a WHOLE lot less. about the same as the aluminum O/P one. (n/m) - ni[x]it 18:33:36 01/20/02 Re: a WHOLE lot less. about the same as the aluminum O/P one - TT6SPD95 18:35:37 01/20/02 Acpt weighs about a 1/3 as much. If memory serves me >>>> - CRuNK™ 18:39:39 01/20/02 Stock I believe was 26 or so.... (n/m) - PiotrC70 18:41:06 01/20/02 I heard like 13-14 for Carbon and 12 lbs for aluminum. (n/m) - PiotrC70 18:39:57 01/20/02 Do your trannies have the input shaft going into the tranny? (n/m) - TT6SPD95 18:48:41 01/20/02 My DS is still stock but I'm sure it does have input to tran (n/m) - PiotrC70 19:12:01 01/20/02 Mine bolts directly to tranny and doesn't slide into it. - TT6SPD95 19:21:54 01/20/02 Ours is exactly the oposite. bolts to diff. and slides into - PiotrC70 19:32:05 01/20/02 Thanks. - TT6SPD95 19:36:11 01/20/02 My problem is this: - TT6SPD95 18:51:19 01/20/02 cf=15lbs, alum=12, stock=38 (n/m) - Chris (NJ) 18:51:52 01/20/02 Whoa, that is a driveshaft. Mine is only 20lbs stock. (n/m) - TT6SPD95 18:53:41 01/20/02
Post a Followup	You cannot reply to this message because you are not logged in.