Subject	My DS is still stock but I'm sure it does have input to tran (n/m)
Posted by	PiotrC70 on January 20, 2002 at 7:12 PM
	This message has been viewed 14 times.
In Reply To	Do your trannies have the input shaft going into the tranny? (n/m) posted by TT6SPD95 on January 20, 2002 at 06:48 PM
Message
Follow Ups	carbon fiber driveshaft - TT6SPD95 18:32:02 01/20/02 a WHOLE lot less. about the same as the aluminum O/P one. (n/m) - ni[x]it 18:33:36 01/20/02 Re: a WHOLE lot less. about the same as the aluminum O/P one - TT6SPD95 18:35:37 01/20/02 Acpt weighs about a 1/3 as much. If memory serves me >>>> - CRuNK™ 18:39:39 01/20/02 Stock I believe was 26 or so.... (n/m) - PiotrC70 18:41:06 01/20/02 I heard like 13-14 for Carbon and 12 lbs for aluminum. (n/m) - PiotrC70 18:39:57 01/20/02 Do your trannies have the input shaft going into the tranny? (n/m) - TT6SPD95 18:48:41 01/20/02 My DS is still stock but I'm sure it does have input to tran (n/m) - PiotrC70 19:12:01 01/20/02 Mine bolts directly to tranny and doesn't slide into it. - TT6SPD95 19:21:54 01/20/02 Ours is exactly the oposite. bolts to diff. and slides into - PiotrC70 19:32:05 01/20/02 Thanks. - TT6SPD95 19:36:11 01/20/02 My problem is this: - TT6SPD95 18:51:19 01/20/02 cf=15lbs, alum=12, stock=38 (n/m) - Chris (NJ) 18:51:52 01/20/02 Whoa, that is a driveshaft. Mine is only 20lbs stock. (n/m) - TT6SPD95 18:53:41 01/20/02
Post a Followup	You cannot reply to this message because you are not logged in.