Subject	My problem is this:
Posted by	TT6SPD95 on January 20, 2002 at 6:51 PM
	This message has been viewed 40 times.
In Reply To	I heard like 13-14 for Carbon and 12 lbs for aluminum. (n/m) posted by PiotrC70 on January 20, 2002 at 06:39 PM
Message	On my Supra I am trying to get a lighter driveshaft but the slider has to be made onto the driveshaft and so far no one has made it much lighter. The carbon fiber is believed to be only a few lbs lighter and I have finally found out it is because of this. I was just wondering what your driveshaft weighs and if you have the slider built into the driveshaft or if you actually slide the driveshaft into the tranny? Thanks, your help is very appreciated. Tony TT6SPD95 11.22@126 Stock Twins, No Nitrous
Follow Ups	carbon fiber driveshaft - TT6SPD95 18:32:02 01/20/02 a WHOLE lot less. about the same as the aluminum O/P one. (n/m) - ni[x]it 18:33:36 01/20/02 Re: a WHOLE lot less. about the same as the aluminum O/P one - TT6SPD95 18:35:37 01/20/02 Acpt weighs about a 1/3 as much. If memory serves me >>>> - CRuNK™ 18:39:39 01/20/02 Stock I believe was 26 or so.... (n/m) - PiotrC70 18:41:06 01/20/02 I heard like 13-14 for Carbon and 12 lbs for aluminum. (n/m) - PiotrC70 18:39:57 01/20/02 Do your trannies have the input shaft going into the tranny? (n/m) - TT6SPD95 18:48:41 01/20/02 My DS is still stock but I'm sure it does have input to tran (n/m) - PiotrC70 19:12:01 01/20/02 Mine bolts directly to tranny and doesn't slide into it. - TT6SPD95 19:21:54 01/20/02 Ours is exactly the oposite. bolts to diff. and slides into - PiotrC70 19:32:05 01/20/02 Thanks. - TT6SPD95 19:36:11 01/20/02 My problem is this: - TT6SPD95 18:51:19 01/20/02 cf=15lbs, alum=12, stock=38 (n/m) - Chris (NJ) 18:51:52 01/20/02 Whoa, that is a driveshaft. Mine is only 20lbs stock. (n/m) - TT6SPD95 18:53:41 01/20/02
Post a Followup	You cannot reply to this message because you are not logged in.