Subject	Re: Speaking of boring over a Z, What's the general consensu
Posted by	Tank on December 26, 2001 at 4:22 PM
	This message has been viewed 44 times.
In Reply To	Speaking of boring over a Z, What's the general consensus>>> posted by crunk300zxtt on December 26, 2001 at 03:22 PM
Message	: On how far you can bore over a Z without pushing the limits of its structural integrity? From what I have been able to find out you can bore the cylinders to 89MM, that's 2MM over stock.
Follow Ups	Speaking of boring over a Z, What's the general consensus>>> - crunk300zxtt 15:22:19 12/26/01 Bore only I think is 3.2L limited by block wall thickness>> - RT 15:42:55 12/26/01 Re: Speaking of boring over a Z, What's the general consensu - Tank 16:22:27 12/26/01 I should probably be on technical with this but..... - crunk300zxtt 16:30:20 12/26/01 Lemme say it before Jack B does.... - Z from Japan 21:02:40 12/26/01
Post a Followup	You cannot reply to this message because you are not logged in.